Per chi vuole provare un suo primo drone racing dopo aver potuto provare già altri droni e capito come si pilotano, l’Eachine Wizard X220s è una delle migliori soluzioni per iniziare. Il vantaggio principale di questo drone è che è un RTF, ovvero un Ready To Fly. Questo significa che per farlo volare basterà veramente poco.
Per chi è alle prime armi deve anche sapere che il frame Wizard o altri simili sono uno dei migliori frame per iniziare ed eventualmente metterci una action camera sopra come una Gopro o similari.
Dove comprare l’Eachine X220S in versione RTF
Scheda tecnica
Item | Specification | |
Eachine Wizard X220S | Wheelbase: 220mm Frame arm: 4mm carbon fiber Weigh: 356g (without battery and camera mount) Take off weigh: 561g Package weigh: 1728g 3K carbon fiber frame kit, 4mm thickness and 15mm width frame arms, the width is 10mm less than Eachine Wizard X220. Frame kit with camera angle scale and 30° camera mount for Runcam 3 Gopro session. Anti-vibration sponges to protect the racer frome crashing. | |
Eachine MN2206 2300KV motor | KV: 2300 Max thrust: 1100G Length: 35MM NO.OF cell: 3-5S Diameter: 28MM Framework: 12N14P Shaft: 5mm Propeller: 5 inch Weight: 28g | |
Eachine 30A BLHELI_S 4 in 1 ESC | Con. current: 30A Peak current (10S): 35A Input voltage: 2-5S BEC: 5V output Programming: YES Firmware: blheli_s Weight: 28g Size: 36*36MM | |
Eachine 1179 800TVL CCD camera | Color: purple Sensor: CCD Resolution(horizontal center): 800TVL Shell size: 25mm*25mm Weight: 11g Resolution: PAL: 1980H×1080 (2MP) Format: PAL Video output: 1.0Vp-p/75Ω Automatic gain control: 0.25/0.50/0.75/1.00 adjustable, up to 55dB. AWB: ON/OFF Exposure mode: electron exposure Electronic shutter: 1/50(1/60) – 1/100000 S Gamma correction: 0.45/1.0 Synchronization method: internal synchronization Lens: standard 2.8mm lens Working voltage: DC12V (Wide Voltage, measured that can be work in 5-13V) Workig current: 70mA (low power consumption) Workig temperature: -20℃–60℃ Humidity: 0%~98% Strong backlighting effect | |
5.8G 72CH 25MW 200mw 600MW switchable transmitter | Video Format : NTSC/PAL Channel: 72CH Operating Temperature : -10~85℃ Connector: RP-SMA Female Antenna connector: RP-SMA Male | |
Omnibus F4 V3 flight controller | Size: 36x36mm Mount holes: 30.5×30.5mm STM32 F405 MCU, Runs Betaflight 3.0.1 firmware, could run faster loop time. Using F4 MCU controls OSD over SPI bus in DMA mode. OSD Configation has been included in Betaflight GUI. SBUS/PPM input (Pinheaders) 6PWM output (1-4Pinheaders and Sh1.0 Plug, 5-6 as Pinheaders) With barometer SPI Sensor MPU6000 Included 128Mbit Flash, please always use BEC for the FC. Supported by BETAFLIGHT and dRonin | |
Flysky FS-i6X 2.4GHz 10CH remote control | Channel: 6-10 (Default 6) Model Type: Fixed-Wing/Glider/Helicopter RF Range: 2.408-2.475GHz RF Power: < 20dBm RF Channel: 135 Bandwidth: 500KHz 2.4GHz System: AFHDS 2A / AFDHS Modulation Type: GFSK Stick Resolution 4096 Low Voltage Warning: < 4.2V DSC port: PS/2 Port PPM Chargeable: No Antenna Length: 26mm (Dual Antenna) Weight: 392g Power: 6V DC 1.5AA*4 Display: STNTransflective Display, LCD 128×64 Lattice, VA 73x39mm, LCD with white backlight Size: 174x89x190mm On-line Update: Yes Color: Black Certificate: CE0678, FCC ID: N4ZFLYSKYI6X | |
Flysky FS-A8S receiver | Channels: PPM 8CH Model type: Multi-rotor Frequency range: 2.408-2.475GHz Band width: 500KHz Band number: 135 RX Sensitivity: -92 dBm 2.4GHz system: AFHDS 2A Modulation type: GFSK DSC port: PPM Transfer method: FHSS Data output: 1.5mm*3 Pin PPM Antenna length: 26mm (Not including brass contacts) Input power supply: 4.0-8.4V Display method: LED No ground interference ( Transmitting and receiving 1 m from the ground): >300m Working current: 40mA Each channel data: depend on the transmitter Channel delay: <15mS Size: 20*14*5.3mm Weight: 1.2g Certificate: CE0678, FCCID: N45ZA8S00 | |
1500mAH 4S 14.8V 75C battery | Capacity(mAh) : 1500 Cells (s): 4 Weight (g): 177 Length(mm): 80 Width(mm): 30 Height(mm): 33 Connector: XT60 | |
Eachine 5051 3-blade propeller | Color: purple Quantity: 10 Pairs Mounting Hole: 5mm |
Dove comprare l’Eachine X220S in versione RTF
Video unboxing e configurazione radiocomando + betaflight:
Come vola il drone: